Porsche Cayenne Forums banner
1 - 1 of 1 Posts

24 Posts
Discussion Starter · #1 ·
When i connect this piwis tester II with PC and Car, the 4 light on the main unit and usb is blinking slow constantly. If you put out the USB connector and then put back in you see all lights light up and then the same again. On the software, it give me prompt like this:
” 99010: This diagnostic system could not be initalised.
99011: Comm. module not connected. Please check.
Repeat communication setup with [F8].
Press [F12] to start simulation mode.”

This problem is your HDD lack one file. If you meet this problem. Please send your order number to [email protected] to contact us to solve it for you by teamviwer.
We will send you a file, then fix this online. It is very quick, will not be over 5 minutes.

More information go to Best quality Piwis Tester II for Porsche V15.6 multi-language
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.